|
click for more info
|
Trim & Tilt
For outboard owners without factory tilt and trim, Bob's Machine Shop has a solution. Designed for motors up to 40 hp, BMS's new hydraulic Tilt & Trim can provide increased performance, better handling and less hassle raising and lowering the motor at the launch ramp.
The Tilt & Trim allows skippers to trim the boat for a smoother, drier ride. When fully trimmed in, it provides a negative 3-degree tuck-under angle for faster starts and quicker on-plane times. After reaching plane, the boat can be optimized for best running angle by trimming the tilt up to its maximum of 75 degrees. A 5-1/2 inch setback is standard.
The hydraulically operated Tilt & Trim weighs only 14 pounds and will accommodate clamp-on motors,not standard BIA bolt pattern style. Call for questions.
The hydraulic pump is mounted inside the boat for protection against the elements.
The Over all mounting dimensions, which are: 11.5" wide by 10" length
BMS's Tilt & Trim is easy to install. It comes with hydraulic pump, wiring harness, control switch, hoses, oil and carries a limited lifetime structural warranty. The pump comes with a 3-year warranty.
v Rated up to 50hp
v Weighs 14 pounds
v 5.5 of setback
v 75 degrees of tilt
v Will accommodate clamp on style motors
v Hydraulic operation
v Pump mounts inside boat
v 12volt motor pump/reservoir ~ mercruiser style
v Limited lifetime warranty
v Comes with pump, wiring harness, control switch, hydraulic hoses & hydraulic oil
|
Price: Au$1,075.00
|
